Futaba G154 Bedienungsanleitung PDF herunterladen (Seite 3)

RATE GYRO INSTALLATION

NOTE: Be sure gyro is mounted as shown; for stabilization of the correct axis.

Helicopter

•

For

rudder

use

Connect connactor (A) to the receiver rud-

der channel and connector [B ] to the rudder

servo.

Aircraft

For

aileron

use

Connect connector (A) to the receiver aileron

channel and connector IB) to the aileron

servo.

Aircraft

For

elevator

(pitch

shaft)

use

Connect connector (A) to the receiver el-

evator channel and connector (B) to the el-

evator servo.

-When

the gyro

mounted 180

out

of phase, the

direction

the correcting mix

will

reversed.

To correct

this

situation,

switch the internal

reverse

amp

switch

"REV".

After

mounting

the

gyro

the fuselage,

recheck its direction of operation,

INSTALLING THE GYRO BODY

• The best mounting position is at the center of

gravity of the aircraft; however, it may also be

installed a short distance away from the center

of gravity.

•

Install

the gyro where there

little

engine vibra-

tion.

•

Attach

the

gyro to the

fuselage

with

double-side

adhesive tape.

UK double sided adhesive

tape

(Clean the mounting sur

face and stick the gyro to

the with soft double-side

adhesive tape.

Use soft double-side

adhesive tape about 3mm

thick and 10mm wide.

CONTROL AMPLIFIER INSTALLATION

• Install the control amp where there is little engine

vibration,

etc.

• Attach the control amp with double-side adhesive

tape.

Us* soft double-side adhesive tape about 3mm thick

and 10mm wide.

Double-side adhesive tape

Attach with soft double-side

adhesive tape.

1 2 3 4

Kommentare zu diesen Handbüchern

Keine Kommentare

Futaba G154 Bedienungsanleitung Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Messgeräte Futaba G154