Futaba GV-1 Bedienungsanleitung PDF herunterladen (Seite 44)

4646

FUNCTIONS

Error display

When adjusting the throttle linkage make sure that ATV and AFR are set to

50% or greater otherwise the GV-1 will not operate and "-ERR-" will be

displayed. Also when setting the "Stop"position make sure it is not higher

than idle or the "-ERR-" will be displayed.

Throttle servo operation test Tst

The servo operating position set with the "limit set" function can be checked.

(Check method)

1Each time the DATA+ or DATA-

key is pressed, the throttle servo

moves to the Idle->High->Stop

point set position.

Rotation sensor monitor (monitor function)

Sen

The rotation sensor signal level can be checked.

(Monitoring method)

1Bring the magnet near the sensor.

The signal level is displayed on the LCD screen.If the display

is 60% or more, the speed can be normally picked up. If less

than 60% is displayed, adjust the sensor position.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49

Keine Kommentare

Futaba GV-1 Bedienungsanleitung Seite 44