Futaba 6XHS Bedienungsanleitung PDF herunterladen (Seite 49)

move the trim tab for that channel until the triangle disappears — this is the nominal neutral

trim. Repeat for the other channel numbers. When you've done all three, hit the DATA

INPUT keys simultaneously, then center the trim tabs. You've initialized the trim.

MODL — Model Select

Your T6XAs/XHs system can store up to six independent sets of model data in its

memory. The Model Select (MODL) function allows you to choose from any of the six sets of

model data.

There are several ways to keep track of which model is in each memory. You may attach

a small piece of white tape to the transmitter front and write the model's name along with the

model setup number, or you may use a notebook, or label the model with its memory number

prominently near its on-off switch inside the fuselage.

Choosing another model memory to load

1. Press on the MODE buttons until MODL appears on the menu.

2. Select the desired model number by pressing the (+) or (–) keys. At this

time, the selected model number will blink on and off.

3. Press the CURSOR key, and the word SET? appears blinking on and off in

the display.

4. Press both the (+) and (–) DATA INPUT keys at the same time. A beep-beep sound indicates

that the selected memory is now the active one.

– 44 –

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 63 64

Keine Kommentare

Futaba 6XHS Bedienungsanleitung Seite 49