Futaba 6XHS Bedienungsanleitung PDF herunterladen (Seite 48)

3. If you are sure you wish to copy the current memory contents into the destination memory,

press both DATA INPUT keys simultaneously again. This carries out the copy function and

overwrites the destination memory. A beep indicates that copying is complete.

TMEM — Trim Memory

The trim memory function is one that you will find extremely useful. It is used after the

model is trimmed out and flying the way you like. Unless you build perfectly, after test flying

and trimming one or more of the trim tabs will be off-center. This is not a problem if you are

only flying one model with the transmitter and you never accidentally move one or more of the

trim tabs, but if you have several models in memory or do accidentally move on or more of the

tabs, all the trims could be different. The trim memory function solves this problem by

memorizing the trim tab positions needed for each model in memory.

When the trim memory function is executed, the trim position is now reproduced when

the trim tabs are moved back to their center position. If the model memory is changed, whenever

that model number is recalled, the original trims are reproduced if the trim tabs are centered.

This means that you never have to worry about where the trim tabs were with the model, the

transmitter keeps track of that information.

Note that the trim levers perform a different function than the subtrims. Subtrims affect

the position the servos are commanded to, the receiver OUTPUTS. Trims affect the transmitter

inputs. (As an example, if you have dual aileron servos and the flaperon function active, aileron

trim moves BOTH servos, but subtrim only affects the individual servo being adjusted.)

Memorizing Trim Positions

1. Press on the (+) or (–) MODE buttons until TMEM appears in the window.

2. With the trim tabs in the desired position, simply press both DATA INPUT

keys at the same time, and a beep-beep sound indicates that the trim

positions have been stored.

3. Now you must move the trims back to their neutral position to get the previous trim

locations. Move the tabs until you feel the detent at each one’s center. If you do this with

each of the models stored in memory, you will know the model is trimmed when the trims

are centered. The throttle trim position is not memorized, so you can always use the trim to

shut the motor off.

Resetting Trim Memory:

If you want to zero out the trim memory, go to the TMEM menu, and observe the marks over

or under the channel numbers 1 2 4. If the trim memory has a non-zero value (meaning you

memorized a trim setting), a little triangle will appear over the corresponding channel. Now

– 43 –

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 63 64

Keine Kommentare

Futaba 6XHS Bedienungsanleitung Seite 48